DinaBase 7 denture adhesive gel, 20 G
DinaBase 7 is a professional bonding agent for third teeth. Unlike conventional bonding cream, it remains on the denture for 7 days, so that just one tube of DinaBase 7 is sufficient for 1-2 months.
€12.98*
Prices incl. VAT plus shipping costs (Kann sich je nach Land ändern)
⁴
- Easy to clean daily
- Temporary, soft-retaining relining
- New application only every 7 days
- One tube of DinaBase 7 lasts for 1-2 months
- DinaBase7 is also used by dentists for temporary relining.
- The material completely fills the cavity between the denture and the palate.
- It remains relatively soft and ensures a comfortable fit.
- The temporary relining creates a suction cup effect for a stable hold.
- The dimensionally stable adhesive layer only needs to be replaced every 7 days.
- The strong adhesion prevents irritating food residue under the denture.
- One tube of DinaBase 7 lasts for 1-2 months.
- The denture can be cleaned easily despite the remaining adhesive.
- The denture can be perfectly adjusted again with each application.
- You can talk, laugh and eat with the same ease as before the third dentures.
Dosage form
How to use
- Heat DinaBase7 in warm water: Place the tube in hot water (60 degrees Celsius) for a few minutes. The tube must be completely covered with water. In the meantime, clean the denture thoroughly and then dry it well. Before applying DinaBase7, the denture must be completely clean and dry, otherwise the material will not adhere properly.
- Open the tube with the cap completely: After heating the tube in hot water, remove the screw cap and pierce the opening with the tip of the cap to create a large, round hole. Twist the tip several times until the hole is fully open.
- Squeeze a cherry-sized portion out of the tube: Once the adhesive gel has been heated sufficiently, squeeze a cherry-sized amount out of the tube.
- Apply the required portion to the centre of the denture: Then spread it evenly over the denture. For the lower denture, the amount should be sufficient to form a sausage that completely fills the cavity. For the upper denture, the gel should cover the entire surface of the denture.
- Spread the material evenly: Spread the material evenly with both thumbs from the centre outwards. If the amount is not sufficient, you can add more.
- Even application of the gel: Ensure that the gel is applied evenly to the entire surface of the denture and that it adheres well, especially to the edges.
- Adapting the denture to the mouth: Before inserting the denture, rinse your mouth thoroughly with water. After inserting the denture, clench your teeth and make distinct lip movements for at least one minute without pressing the denture with your fingers. This allows the denture to fit perfectly.
- Removing excess material: Rinse the denture under cold water to remove excess material from the edges. Then cut off the material with small scissors. Done! If no remnants need to be removed after fitting, too little material may have been used.
Ingredients
| Gramm: | 20 |
|---|
Anwendungshinweise
Cutsomers also bought
Content: 60 Stück
€25.41* €29.90*
Content: 30 Stück
€6.65*
Content: 30 Stück
€6.65*
Content: 12 Stück
ab €8.55*
Content: 5 Gramm
€7.20*
Content: 24 Stück
€7.99* €9.40*